![\"Rubber](\"http:\/\/modela.airynothing.com\/wp-content\/uploads\/2016\/08\/Rubber-in-the-door-latch.jpg\")
<\/a><\/p>\nOnce I got the new springs for the latches (from a latch rebuild kit from Bratton’s), I set about the rebuild. They were pretty dirty to start with.<\/p>\n
First task was to pull the pin holding the latch in. Note that there’s no spring there – thus the use of the rubber pieces. <\/p>\n Another spring (note it’s mostly gone) needed me to bend back the metal. I’m always a little weirded out by bending metal in a car, because I’m worried about getting it back where it started. But I’ve done it a few times now on other projects, so just forged ahead. <\/p>\n I was able to figure out the placement of one of the springs because the shards of it were still in the latch when I took it apart (and was smart enough to take the above picture before I took it apart!). This one was relatively easy to get back in, and then I bent back the metal I had pulled apart.<\/p>\n However, since the spring to push the latch back out was gone, I had to do a little trial and error to figure it out. I did a google search to try and find pictures showing the spring placement. I came up empty, though I did find a short video of someone showing off their before-and-after latch rebuild. I played that video and stopped it on the new latch about 4 times. <\/p>\n Even after all that, I got the latch wrong once and had to remove and re-do the spring. Here’s what I finally settled on, which seems to make the latch pop back out. <\/p>\n In the end, here are the two rebuilt, cleaned latches. <\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n<\/a><\/p>\n